Peel And Seal Self Stick Adhesive Roof Underlayment With High Wind Tolerance

Peel and Seal Self Stick Roofing Roll Adhesive Roof Underlayment

Introduction:

Peel and seal self stick roofing roll is ideal for roofs and surfaces that are visible fire is prohibited. Its top surface is covered with black PE film, Aluminum film, fine sand or high tensile fabric. Back side is easy removable release film. It can be used on many surfaces including metal roofs, mobile homes, concrete roofs, wooden roofs, etc. 

Benefits:

This product is made of smooth films or sands and a rubberized asphalt adhesive back, making it flexible and self-adhering. It will not tear, crack or dry out over time. It is designed specifically to reflect heat and resist water and exposure to other elements without any additional coverage needed. 

Storage:

1. Store rolls on horizontal position to prevent damage

2. Avoid direct sunlight and rain

3. Store rolls in a ventilated and clean dry location.

 After the roof is prepped, you will simply peel off the release paper on the back of your peel and seal, and roll it out onto your surface, using a hand roller to smooth out any creases. Finally, use a sharp knife to cut off the desired length. 36in. Wide Rolls have 3in. lines on each side. No special tools needed. High wind tolerance. Made in the U.S.A. Also Tested to Meet ASTM D 1970 Requirements.

Application fields and installation:

1.It can be installed on an EPDM roof, but you must primer it with primer.

2.It is very simple to install. Simply make sure your surface is clean, smooth, dry and free of any loose debris. 

3.Be sure to primer your surface with an asphalt primer before applying it.

4.After the roof is prepared, you will simply peel off the release film on the back of your pell and seal roll, and roll it out onto your surface, using a hand roller to smooth out any creases. 

5.Finally, use a sharp kinfe to cut off the desired length. No special tools needed.

6.High wind tolerance. 

Specification Data: