3mm Torch Applied SBS Modified Bitumen Waterproofing For Roofing Engineering

3mm Torch Applied SBS Modified Bitumen Roofing Waterproof Membrane Sheet Roll

Introduction:

Elastomer (SBS) modified bitumen waterproof membrane uses styrene-butadiene-styrene (SBS) thermoplastic elastomer modified bitumen as impregnation and coating material, with polyester felt and glass fiber reinforced polyester felt as tires Base, the upper surface is covered with polyethylene film, fine sand or mineral sheet and other insulation materials can be rolled sheet-like waterproof material.

Product specifications: product width 1.0m, length 10m / roll or 7.5m / roll; nominal width 1.0m.
Thickness specification: 3.0mm, 4.0mm.
Low temperature flexibility: -10 °, -15 °, -20 °.
Covering material: PE film, AL (aluminum) film, S (sand grain) surface, M (rock blade) surface
Note: The sand surface is divided into ordinary sand and colored sand. Colored sand has grass green and wine red.

Advantage:

1. Excellent low temperature flexibility, good tensile resistance and high extensibility;
2, using reliable and reliable brand-name raw materials, advanced modern production technology and equipment;
3. A sound quality assurance system and a complete service system.

Usge Area:

Various industrial and civil: waterproofing for roofing engineering, underground engineering, municipal engineering, especially suitable for high latitudes and cold areas

Applying key points:

Adopt hot melt construction. When applying the hot melt method, pay attention to the heating should be uniform, sufficient and moderate; the yin and yang corners should be rounded or 45 ° chamfered; the width or length of the additional layer should be 500mm, with two sides on each side. 250mm; It is advisable to heat-seal the edges of the overlap area, and it is appropriate to overflow the strip of asphalt to the overlap area.

Storage and transportation:

When storing during transportation, different types and specifications of products should be stored separately and should not be mixed; avoid sunlight and rain, pay attention to ventilation; storage temperature should not be higher than 50 °, only single-layer storage during storage, only Stand on a single layer; prevent tilting and lateral pressure during transportation, and cover with cloth when necessary.